Aluminium Sheet Circle Aluminum wafer for aluminum pot, street
lights, water carrier box
Our company produces all series of aluminum wafer, and customer can
customized the aluminum wafer of
various diameters. The process technology can be divided into 2
types: cold and hot rolling, and the products
are widely used in deep drawing aluminum pot, aluminum pot, grate,
street lights, cosmetics boxes and other
fields. Our factory is located in the important town of aluminum
processing and peripheral aluminum ore
resources is rich, so the cost will be lower. It has advantages of
good quality and low price.
1. NC full automatic. The production line neither needs workers to
contact any materiel during the production
of from the coil start to roll, until the entire volume of
materials all completed blanking, nor needs any
adjustment, fundamentally completely eradicate the production
safety hidden danger and product quality
problems of the ordinary punch punching.
2. The production line can use roll material directly to product
aluminum wafer and do not need the slitting and
crosscutting processing of roll material, thus reduce production
processes, production costs, and the
possibility of damage the surface of roll material, and the
produced aluminum wafer can be ensured no oil and
3. The production line make full use of the width of the roll
material, using high precision servo motor drive
control system and make the distance of wafer to the edge of
material and the spacing of wafer is reduced to
minimum, fundamentally reduce the amount of waste material, so that
the utilization rate of raw materials
reached more than 80%.
4. The production speed can reach 40-50 pieces per minute and
improve the production efficiency.
5. Due to use the mould design of modular, when convert the
production specifications of wafer, the
conversion time can be reduced to less than 15 minutes. The
diameter range of the wafer can be produced is
85mm to 750mm.
6. Present uncoiling system, six type leveling machine, high rigid
mechanical press, automatic palletizing
system and so on, to ensure the high quality of wafer products.
1. blank material cutting (cut into square)
2. blanking (blanking into the wafer you want). If it is roll
material, then add an open book in front. The main
equipment of automatic wafer blanking production line processing
aluminum wafer blanking production line: feeding trolley, uncoiler,
leveler, feeding machine, swing unit, special
closed single point mechanical press, quick die change device,
stacking unit, scrap shear, hydraulic system
and electric control system etc..